1 Make sure your spiral is completely dry. It is not
possible to load film onto a spiral that is even so much as damp. You may have
found this out already. Check that there is nothing stuck in the grooves. Emulsion can be stripped of the edge of the
film during loading/unloading so rinse spiral thoroughly after use.
2 Trim the leader off your film. If you are
lucky/careful when you rewind your film the leader will be left sticking out.
It is the curved bit at the start of your film. You want to remove this bit and
be left with a slightly rounded end which is easier to feed into the spiral.
Cut between the sprocket holes as you do not want any bits sticking out to
catch on the spiral . If you do not have the leader sticking out you have two
options.
a) open the cassette, which you may already
be doing. Remove the top from the cassette and slide the film out , try to keep
the film from unrolling at this stage. Trim as above.
b)Use a film leader retriever to pull the
leader back put of the cassette. You can get one from a camera shop.
3 Load film. Gently feed the film onto
the spiral. If the film is still in the cassette pull out a couple of inches,
if you had to remove the film you will probably have to let it go now. Try not
to let it drop to the floor as it will get covered in stuff.You will now have
about four feet of film swinging about which makes things very awkward
particularly if you are not very tall. You could , if you have a clean surface
to work on , just let the film drop a few inches on to that. If you are using a
Paterson type spiral with the ball bearings at the start you just have to feed
the film over the ball bearings until the sprocket holes catch on the bearings.
If you are using a Jobo type spiral you will
have to apply a little pressure with your thumbs onto the edge of the film to
hold it. There is a groove kinda thing just where the film goes in.
4 Wind the film on. With the Paterson
spiral this is fairly easy. If you still have the film in the cassette you can
pull a fair piece out now. Hold the spiral in both hands and rotate alternate
sides back and forth .Don't push the film on ,wind it on.
With the Jobo spiral when you rotate one side
release your grip on the film edge on the opposite side.
5 Take your time. Don't try to rush
the film on. If both film and spiral are dry and you took care when first
loading the film in, making sure both edges of the film are in the same groove
on the spiral the film should go on fine.
6 Trim of the end. When you reach the
end cut the film leaving any tape that was holding the film on the reel.
7 Put the film in the tank. Slide the
spiral over the centre spindle, put it back in the tank and put the lid on
securely.
8 Disaster. Don't panic.If you feel
you are forcing the film it is stuck , if it makes crunching noises it is stuck
,if it is coming of the spiral somewhere other than where it goes on it is not
in right. Just stop and slowly pull the film back out. Sometimes just pulling a
few inches back out then trying again works fine if it was sticking. Likewise
sometimes gently squeezing the sides together a couple of times can also free
of a sticking film .
If the worst comes to the worst you will have
to take the film of and start again. If you had to take the film out of the
cassette this is a pain because you are now stuck in the dark but if you were
able to keep the film in the cassette you just have to wind it back in put the
light on and then the kettle and try later.
